Using Options
223
7
7
7
7
7
7
7
7
7
7
7
7
10. Plug the printer’s power cord into an electrical outlet.
11. Turn on the printer.
To confirm that the Hard Disk Drive is installed correctly, use the
printer’s control panel menus to print a status sheet. See “Printing
a Status Sheet” on page 246 for instructions. If the drive is not
listed on the status sheet, try reinstalling the drive. Make sure that
the connector on the Hard Disk Drive is securely connected to the
socket on the circuit board.
Note:
If you are using Windows, and EPSON Status Monitor 3 is not
installed, you have to make settings manually in the printer driver. Click
the Update the Printer Option Information Manually button on the
Optional Settings menu, then click Settings. Then select the Optional
HDD Unit check box on the Optional Settings dialog box and click OK.
Removing the Hard Disk Drive
Follow these steps to remove the Hard Disk Drive:
c
Caution:
Before you remove the Hard Disk Drive, be sure to discharge any
static electricity by touching a grounded piece of metal.
Otherwise, you may damage static-sensitive components.
w
Warning:
Becarefulwhenworkinginsidetheprinterassomecomponents
are sharp and may cause injury.
1. Turn the printer off and unplug the power cord.
2. Remove all interface cables from the interface connectors.
To Next Page
Loading...
