312
Troubleshooting
C Toner Out
See “XXXX Toner Out” on page 324.
Duplex Mem Overflow
There is not enough memory for duplex printing. The printer
prints only on the front and ejects the paper. To clear this error,
follow the instructions below.
If
Off
is selected as the
Auto Cont
setting on the control panel’s
Setup Menu, press
N Start/Stop to print on the back of the next
sheet, or press the
q
Job Cancel button to cancel the print job.
If
On
is selected as the
Auto Cont
setting on the control panel’s
Setup Menu, printing continues automatically after a certain
period of time.
Face Down Full
The output tray is full of printouts, and the printer has stopped
printing. Remove the printouts from the output tray, and press
the
N Start/Stop
button
to continue printing. The output tray can
hold up to 250 sheets.
Form Data Canceled
Unable to store form overlay data on the printer’soptionalHard
Disk Drive. Either the drive is full, or the maximum number of
form overlay files has been reached. Delete any form overlay files
you no longer need, then try storing the new overlay again.
To clear this error, select
Clear Warning
from the control panel’s
Reset Menu. For instruction about accessing the control panel
menus, see “How to access the control panel menus” on page 166.
To Next Page
Loading...
