15. Close the front cover.
16. Press the Stop/Reset key to reset the machine and clear the indicator message.
Note:
The machine must complete a calibration cycle after a toner cartridge has been replaced. If you open
the scanner unit or front cover before the machine is reset, the calibration stops, then starts over again
after the cover is closed.
Removing All Toner Cartridges
Note:
Be careful not to spill toner while removing a toner cartridge. If toner spills, immediately wipe it off with a
soft, dry cloth.
By selecting the EJECT MODE in the PRINTER MODE menu, all toner cartridges can be removed.
Follow the procedure described below to use the EJECT MODE.
1. With the main screen displayed, press the l key to display the PRINTER MODE screen.
2. Press the d key to select T/C CHANGE and then press the Select key.
3. Press the d key to select EJECT MODE and then press the Select key.
AcuLaser CX16 Series Printer / Copier / Scanner User’s Guide
Replacing Consumables 125
To Next Page
Loading...
Need help?
General
