Specifying the Zoom Ratio
The zoom ratio can be specified either by selecting a preset zoom ratio or by specifying a custom zoom
ratio.
Selecting a Preset Zoom Ratio
1. In the main screen (Copy mode), press the u or d key to select the current zoom ratio setting, and
then press the Select key.
2. Press the u or d key to select FIXED, and then press the Select key.
3. Press the u or d key to select the desired zoom ratio, and then press the Select key.
The main screen (Copy mode) appears again.
Specifying a Custom Zoom Ratio
1. In the main screen (Copy mode), press the u or d key to select the current zoom ratio setting, and
then press the Select key.
2. Press the u or d key to select MANUAL, and then press the Select key.
3. Use the keypad to type in the desired zoom ratio, or press the u or d key to specify the zoom ratio,
and then press the Select key.
The main screen (Copy mode) appears again.
Note:
Each press of the u or d key changes the zoom ratio by 1%.
A setting between 50% and 200% can be specified.
Selecting the Media Tray (AcuLaser CX16NF only)
Note:
If an optional 500-sheet paper cassette unit is not installed, this setting is not available.
1. In the main screen (Copy mode), press the u or d key to select the current media tray setting, and
then press the Select key.
2. Press the u or d key to select the desired media tray, and then press the Select key.
The main screen (Copy mode) appears again.
AcuLaser CX16 Series Printer / Copier / Scanner User’s Guide
Using the Copier 80
To Next Page
Loading...
Need help?
General
