3. Prepare the attachment.
Note:
Be sure to place the attachment on a level surface.
4. Lift the machine and place it on top of the attachment, making sure that the positioning pins on the
attachment correctly fit into the holes on the bottom of the machine.
w
Warning:
This machine weighs approximately 21 kg (46 lb) when it is fully loaded with consumables.
5. Open Tray 1 and reattach the dust cover.
Next, install the duplex option.
Installing the Duplex option
Note:
The illustrations in the following installation procedure show the machine with Tray 2 installed;
however, the installation procedure would be the same if the attachment was installed.
1. Turn off the machine and disconnect the power cord and interface cables.
AcuLaser CX16 Series Printer / Copier / Scanner User’s Guide
Installing Accessories (AcuLaser CX16NF only) 203
To Next Page
Loading...
