37
• Regular Cleaning Alert Settings
You can change the password using the product control panel.
Note: To change the password using Web Config, select Change Administrator Password on the
Product Security tab and enter the necessary information.
1. Select the home icon, if necessary.
2. Select Settings.
3. Select System Administration.
4. Select Admin Settings.
5. Select Admin Password > Change.
6. Enter your current password.
Note: The default password is the product's serial number. To locate the serial number, check the
label attached to the back of your product. If you restore the product to default settings, the
administrator password resets to the product serial number.
7. Enter a new password.
8. Enter the new password again to confirm it.
Note: Keep a copy of your password in a safe place.
9. Select Lock Setting > On to enable access restriction.
Note: To set the lock setting using Web Config, select Control Panel on the Device Management
tab and select Panel Lock > On.
When the control panel is locked, you must enter the password to access any of the locked settings. You
can reset the administrator password by selecting Reset on the Admin Password screen. To disable
access restriction, select Settings > System Administration > Admin Settings > Lock Setting > Off.
Parent topic: Using the Control Panel
Setting Up Epson Connect Services
If you did not activate your product's email address for use with Epson Connect when you set up your
product, you can activate it using the product control panel.
To Next Page
Loading...
Need help?
General