103
Input Signal Settings - Signal Menu
Normally the projector automatically detects and optimizes the input signal
Setting Options Description
settings. If you need to customize the settings, you can use the Signal menu.
Aspect See the list of Sets the aspect ratio (width-to-height
The available settings depend on the currently selected input source.
available aspect ratio) for the selected input source.
ratios.
You cannot select settings on the Signal menu when the current input
Tracking Varying levels Adjusts the signal to eliminate vertical
source is one of the following:
a
available stripes in computer images.
• USB Display
Sync. Varying levels Adjusts the signal to eliminate fuzziness
• USB
available or flickering in computer images.
• LAN
Position Up Adjusts the image location on the screen.
Down
Left
Right
Auto Setup On Automatically optimizes computer image
quality (when On).
Off
Overscan Auto Changes the projected image ratio to
make the edges visible by a selectable
(For component Off
percentage or automatically.
video and RGB
4%
video signal input)
8%
You can restore the default settings of the Tracking, Sync., and
Position settings by pressing the [Auto] button on the remote control.
a
To change settings for an input source, make sure the source is connected and
select that source.
Setting Options Description
Resolution Auto Sets the input signal resolution if not
detected automatically using the Auto
Normal
option.
Wide
To Next Page
Loading...
Need help?
General
Weight and Dimensions
