34
Turning On the Projector
• "Projector Setup Settings - ECO Menu" p.115
Warning
• Never look into the projector lens when the lamp is on. This can damage your
Home Screen
eyes and is especially dangerous for children.
• During projection, do not block the light from the projector with a book or other
The Home screen feature allows you to easily select an image source and
objects. If the light from the projector is blocked, the area on which the light
access useful functions. You can display the Home screen by pressing the
shines becomes hot which could cause it to melt, burn, or start a fire. Also, the
[Home] button on the control panel or remote control. The Home screen is
lens may get hot due to the reflected light which could cause the projector to
also displayed when you turn on the projector and no signal is being input
malfunction. To stop projection, use the A/V Mute function, or turn off the
from the selected input source.
projector.
Press the arrow buttons on the control panel or remote control to select a
• A mercury lamp with high internal pressure is used as the projector's light
source. If the lamp is subjected to vibrations or shocks, or if it is used for an
menu item, and then press [Enter].
overly extended length of time, the lamp may break or it may not turn on. If the
lamp explodes, gases may escape and small fragments of glass may be scattered
which could cause an injury. Be sure to observe the instructions below.
• Do not disassemble or damage the lamp or subject it to any impacts.
• Do not bring your face close to the projector while it is in use.
• Particular care should be taken when the projector is installed to a ceiling, as
small pieces of glass may fall down when the lamp cover is removed. When
cleaning the projector or replacing the lamp yourself, be very careful not to
allow such pieces of glass to get into the eyes or mouth.
If the lamp breaks, ventilate the area immediately, and contact a doctor if any
fragments of broken glass are inhaled or get into the eyes or mouth.
• When the Direct Power On setting is set to On in the projector's
Extended menu, the projector turns on as soon as you plug it in.
a
Note that the projector also turns on automatically in cases such as
recovery from a power outage.
s Extended > Operation > Direct Power On
• If you select a specific port as the Auto Power On setting in the
projector's Extended menu, the projector turns on as soon as it
detects a signal or cable connection from that port. (Set Standby
A
Select the source you want to project.
Mode to Communication On in the projector's ECO menu first.)
B
Displays the QR code and projects data on a smartphone or tablet device.
s Extended > Operation > Auto Power On
C
Displays the Help screen.
D
Displays the projector's menu.
gg Related Links
• "Home Screen" p.34
E
Performs menu options assigned to Home Screen setting in the projector's
• "Projector Setup Settings - Extended Menu" p.107
Extended menu.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
