Using the PostScript Printer Software (Windows) 125
4
4
4
4
4
4
4
4
4
4
4
4
Follow these steps to use the Reserve Job function when printing
from any application:
1. Click Print under the application’s File menu.
2. Click the Properties button, and then click the Job Settings tab.
3. Specify the desired Reserve Job settings in the dialog box that
appears.
4. When printing multiple copies, select the Collated check box
in the Advanced settings of the printer driver.
5. When you are done with the settings, click the Print button to
print.
Note:
Refer to the printer’s Reference Guide for details on the individual
settings in the Job Settings sheet.
Using AppleTalk under Windows 2000 or NT 4.0
Use the following settings if your machine is running Windows
2000 or Windows NT 4.0, and the printer is connected through an
network interface using the AppleTalk protocol:
❏ Use SelecType to set the Emulation Mode-Network item to
PS3. Using the default Auto setting will cause an extra,
unneeded page to be printed.
❏ On the Device Settings sheet of the printer’s Properties dialog
box, make sure that SEND CTRL-D Before Each Job and
SEND CTRL-D After Each Job are set to No.
❏ TBCP (Tagged binary communications protocol) cannot be
used as the Output Protocol setting.
To Next Page
Loading...
