228 Replacing the Consumable Product
Note:
When the optional Stacker is installed, lower the Stacker after
closing cover A.
Fuser Unit
Prepare a new fuser unit for replacement when you get a message
informing you to do so.
Handling precautions
Note the following handling precautions before replacing the
fuser unit:
❏ Do not touch the surface of the fuser unit. Doing so may
impair print quality.
w
Warning:
❏ The fuser unit can be very hot if the printer has been in use.
Turn the printer off and wait for 40 minutes until the
temperature has subsided before replacing the fuser unit.
❏ Keep the fuser unit out of the reach of children.
Replacing the fuser unit
Follow these steps to replace the fuser unit.
To Next Page
Loading...
