Setting Up Your Printer on a Network 189
6
6
6
6
6
6
6
6
6
6
6
6
❏ On the Device Settings sheet of the printer’s Properties dialog
box, make sure that SEND CTRL-D Before Each Job and
SEND CTRL-D After Each Job are set to No.
❏ TBCP (Tagged binary communications protocol) cannot be
used as the Output Protocol setting.
Installing the Printer Driver from the CD-ROM
This section describes how to install the printer driver in the
clients when setting the network system as follows:
❏ Additional drivers are not installed in the Windows XP, 2000,
or NT 4.0 printer server.
❏ The printer server’s operating system is Windows Me, 98, or
95, and the client’s operating system is Windows XP, 2000, or
NT 4.0.
The screen shots on the following pages may differ from those
that appear on your screen, depending on the version of the
Windows operating system that you are using.
Note:
❏ If you are installing the printer driver is a Windows XP, 2000, or
NT 4.0 client, you must access Windows XP, 2000, or NT 4.0 as
the Administrator.
❏ If additional drivers are installed or the computers of the server and
clients use the same OS, you do not have to install the printer drivers
from the CD-ROM.
Follow these steps to install the printer driver directly from the
CD-ROM:
To Next Page
Loading...
