Troubleshooting 273
9
9
9
9
9
9
9
9
9
9
9
9
Paper does not feed properly
Problems Printing in the PostScript 3 Mode
The problems listed in this section are those that you may
encounter when printing with the PostScript driver. All
procedural instructions refer to the PostScript printer driver that
shipped with your printer.
Cause What to do
The paper guides are not set
correctly.
Make sure that the paper guides in all
the paper cassettes are set in the correct
paper size positions.
The paper source setting may
not be correct.
Make sure that you have selected the
correct paper source in your
application.
There may be no paper in the
cassettes.
Load paper.
The size of loaded paper
differs from the control panel
setting.
Make sure that the correct paper size is
set in the control panel’s Paper Source
and MP Tray Size settings.
Too many sheets may be
loaded in a cassettes.
Make sure that you have not tried to
load too many sheets of paper. For the
maximum paper capacity for each
paper source, see “MP tray” on page 15.
If paper does not feed from the
optional 550-Sheet Paper
Cassette Unit A4, the unit may
not be installed properly.
For instructions on installing the unit,
see “550-Sheet Paper Cassette Unit A4”
on page 191.
To Next Page
Loading...
