244 Troubleshooting
w
Warning:
❏ Unless specifically instructed in this guide, be careful not to
touch the fuser, which is marked CAUTION HOT
SURFACE, or the surrounding areas. If the printer has been
in use, the fuser and the surrounding areas may be very hot.
If you must touch one of these areas, wait 40 minutes to allow
the heat to subside before doing so.
❏ Do not insert your hand deep into the fuser unit as some
components are sharp and may cause injury.
Jam A (Cover A)
When a paper jam occurs in the location shown in the illustration
below, the Jam A message appears on the printer’s LCD panel.
Follow these steps to clear paper jams from cover A.
To Next Page
Loading...
