136 Using the PostScript Printer Software (Macintosh)
1. In the Apple menu, select Chooser. The Chooser dialog box
appears.
2. Make sure that AppleTalk is active.
3. Click the AdobePS icon to select it. The name of your printer
appears in the Select a PostScript Printer box.
Note:
By default, the six-digit MAC address is displayed after the printer
name if the printer is connected through an optional network card.
Refer to your network card manual for details.
4. Click on the name of your printer to select it. The Create
button appears.
Note:
If your computer is connected to more than one AppleTalk zone,
click the AppleTalk zone your printer is connected to in the
AppleTalk Zones list.
5. Click Create.
A message will appear marking the completion of the setup.
The Chooser dialog box will be displayed again.
(The Create button changes into the Setup button.)
To Next Page
Loading...
