Troubleshooting 305
9
9
9
9
9
9
9
9
9
9
9
9
Stacker Full
The output paper at the Stacker is full. Remove the paper that was
output and press the N Start/Stop button. Printing resumes.
Status Sheet
The printer is printing the status sheet.
Sleep
The printer is currently in the power-save mode. This mode is
canceled when the printer receives print data or the Reset button
is pressed.
Toner Low
The imaging cartridge has less than 10% of toner remaining and
need to be replaced.
See “Replacing the imaging cartridge” on page 224 for
instructions.
When you set the TonerOut setting in the Setup menu to Stop,
you can continue to print until the Replace Toner error message
appears. It is recommended that you wait until this message
appears before replacing the imaging cartridge as remaining
toner may spill during replacement procedure. When printouts
become faint, see “Replacing the imaging cartridge” on page 224
for instructions.
Note:
Replacement of the imaging cartridge is not yet necessary when the
Toner Low message appears. Toner may remain in the imaging cartridge
and spill out if you remove the imaging cartridge at this level. Replace
the imaging cartridge when the Replace Toner message appears.
To Next Page
Loading...
