1.2.5 Default Setting Mode 1
You can change some parameters that the printer refers to at printer initialization.
1.2.5.1 Setting Method
Refer to the following flowchart for the default setting mode 1.
START
Language selection sheet
C hange the language?
YES
NO
Select the m enu, select m ethod and
current setting are printed.
T u rn th e p rin te r o ff to s a v e th e
settings.
END
R e fe rrin g to th e F o n t a n d T e a r o ff/ B in
LED s, push
Tear off/B in
s w itc h to
select the m enu.
R eferring to the P ause and Paper
O u t L E D s , p u s h
Load /Eject
sw itch
to change the setting value.
H o ld in g d o w n
Tear off/ B in
s w itc h ,
tu rn o n th e p rin te r.
Push down
Load/Eject
s w itc h to
select the aim ed language.
Push down
Tear off/ B in
sw itch.
Finish?
Figure 1-4. Flowchart for Default Setting Mode 1
1.2.5.2 Setting Items
Setting values available for the default setting mode including factory settings are as shown in the
following table:
Table 1-12. Setting Values Available for Default Setting Mode 1
Items
Setting values
(BOLD font : factory setting)
Skip over perforation
On,
Off
Auto tear off
On,
Off
Auto line feed
On,
Off
Print direction
Bi-D
, Uni-D
I/F mode
Auto
, Parallel, Option
Auto I/F wait time
1
0 sec
., 30 sec.
Software
ESC/P
, IBM 2380 Plus
0 slash
0
, Ø
High speed draft
On
, Off
Input buffer
On
, Off
Buzzer
On
, Off
Auto CR ( IBM 2380 Plus )*1
On,
Off
IBM character table
( IBM 2380 Plus )*1
table 2
, table 1
*1: This setting is effective when the IBM 2380 Plus emulation is selected only.
To Next Page
Loading...
Need help?
General
