4.2.8 Platen Removal
1. Remove the PAPER GUIDE ASSEMBLY, top cover, front cover, paper eject cover, knob and
tractor unit. (See Section 4.2.3.)
2. Remove the upper housing. (See Section 4.2.4.)
3. Remove 2 CBS (M3 × 8) screws securing the COVER,PLATEN.
4. Rotating the teeth of the PLATEN SHAFT HOLDERs forward, disengage them from the
Left/Right Side Frame.
5. Slide the PLATEN right a little and remove it by lifting it up.
$'-8670(17
After replacing the platen, perform the platen gap adjustment. (Refer to
Chapter 5.)
CBS(M 3 x 8)
C over P laten
PLATEN
PLATEN SHAFT HOLDER
PLATEN SHAFT HOLDER
Left Side Fram e
R ight S ide Fram e
Figure 4-8. Platen Removal
To Next Page
Loading...
