EasyManuals Logo

Epson LX-300+ User Manual

Epson LX-300+
138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #103 background imageLoading...
Page #103 background image
4-6 Troubleshooting
R4C4610
Rev. C
A5 size TRBLE.FM
6/28/00 Pass 3
L
Proof Sign-off:
SEI Y.Ohkawara K.Kono
K.Kono
SEI M.Kauppi
The print position is not what you expected
Paper Handling
Single sheets do not feed properly
Printing starts too high or too low on the page, or the bottom
part of one page is printed at the top of the next page.
Your software application settings may be incorrect. Check the margin
or top-of-form position setting in your application software.
Page length does not match the length of the paper.
The page length setting in your application may be incorrect. Check
the page length set by your software and adjust it if necessary.
If you are using continuous paper, change the page length in the Printer
Setting mode. See “About Your Printer’s Default Settings” on page
2-25.
Regular gaps occur in the printout.
One-inch skip-over-perforation may be set. Set skip-over-perforation
to off in the Printer Setting mode. See “About Your Printer’s Default
Settings” on page 2-25.
Paper does not feed.
Continuous paper may be left in the printer. Remove the continuous
paper. Set the paper-release lever to the single-sheet position. Insert a
new sheet.
Move the paper a little to the left.

Table of Contents

Other manuals for Epson LX-300+

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson LX-300+ and is the answer not in the manual?

Epson LX-300+ Specifications

General IconGeneral
EmulationEpson ESC/P, IBM PPDS
Print Method9-pin, impact dot matrix
InterfaceParallel
Paper HandlingFriction feed
Dimensions366 x 275 x 159 mm
Paper Width4 - 10 inches

Related product manuals