Epson LX-300+ User Manual

A-4
R4C4610
Rev. C
A5 size APPENDIX.FM
6/28/00 Pass 3
L
Proof Sign-off:
SEI Y.Ohkawara K.Kono
K.Kono
SEI M.Kauppi
Printer Specifications
Mechanical
Printing method: 9-pin impact dot matrix
Printing speed: High speed draft 300 cps at 10 cpi
Draft 225 cps at 10 cpi
270 cps at 12 cpi
225 cps at 15 cpi
Draft condensed 191 cps at 17 cpi
225 cps at 20 cpi
NLQ 56 cps at 10 cpi
67 cps at 12 cpi
56 cps at 15 cpi
Printing direction: Bidirectional logic seeking for text and
graphics printing. Unidirectional text or
graphics printing can be selected using
software commands.
Line spacing: 1/6-inch or programmable in 1/216-inch
increments
Printable columns: 80 columns (at 10 cpi)
Resolution: 240 × 144 dpi maximum (NLQ)
Interfaces: Standard bidirectional, 8-bit, parallel
interface with IEEE 1284 nibble mode
support and EIA-232D serial interface
Paper feed methods: Friction (top paper entry)
Push tractor (rear paper entry)
Pull tractor (bottom or rear paper entry)
Push and pull tractor (optional)
Cut-sheet feeder (optional)
Roll paper holder (optional)
Paper feed speed: Continuous 3 inches/second
Intermittent 88 ms/line at 1/6-inch
line spacing

Epson LX-300+ Specifications

General

Emulation	Epson ESC/P, IBM PPDS
Print Method	9-pin, impact dot matrix
Interface	Parallel
Paper Handling	Friction feed
Dimensions	366 x 275 x 159 mm
Paper Width	4 - 10 inches