4-8 Troubleshooting
R4C4610
Rev. C
A5 size TRBLE.FM
6/28/00 Pass 3
L
Proof Sign-off:
SEI Y.Ohkawara K.Kono
K.Kono
SEI M.Kauppi
Options
When you use the cut-sheet feeder, the paper does not
feed properly
Check that the paper size and thickness are within the specified range.
See the paper specifications in “Printer Specifications” on page A-4.
When you use side-crimped multipart forms, the copies may not align
with the original. If this happens, raise the paper guide to keep the
printing position accurate.
The paper does not eject properly.
The page may be too long. Tear off the fresh supply of paper and eject
the page from the printer. Use only paper that is within the specified
length range described in “Printer Specifications” on page A-4.
When you switch between single sheets and continuous paper,
the beeper sounds five times and the PAUSE light comes on.
You may have tried to change the paper-release lever position while
paper remained in the printer. Return the paper-release lever to the
previous position and eject the paper. Then change the paper-release
lever position.
The paper does not feed.
The cut-sheet feeder may be incorrectly installed on the printer. Re-
install it as described in “Cut-sheet feeder” on page 2-32.
Make sure the paper-release lever is pushed back to the single-sheet
position.
You may have loaded too many sheets in the cut-sheet feeder’s bin.
Paper may be jammed near the print head. Look for a paper jam.
To Next Page
Loading...
Need help?
General
