2-8 Using the Printer
R4C4610
Rev. C
A5 size USING.FM
6/28/00 Pass 3
L
Proof Sign-off:
SEI Y.Ohkawara K.Kono
K.Kono
SEI M.Kauppi
6. Turn on the printer.
7. Make sure the printer cover is closed. Press the
LF/FF
button
to feed the paper to the loading position. When the printer
receives data, it begins printing automatically.
8. After you finish printing, follow the steps in the next section
to tear off your printed document. If the first printed line on
your page appears too high or low, you can change its position
by using the micro adjust feature. See “Adjusting the top-of-
form position” on page 2-15.
c
Caution:
Never use the knob to adjust the top-of-form position; this may
damage the printer or cause it to lose the top-of-form position.
When you send more data, the paper automatically feeds back to
the loading position. If you want to change the position where
printing begins on the page, follow the steps in “Printing with the
push tractor” on page 2-5 to adjust the loading position.
Removing a printed document from the push tractor
To remove the printed document, follow these steps:
1. Press the
Tear Off
button. Make sure the
Tear Off
lights are
flashing. (This indicates your paper is at the current tear-off
position.)
To Next Page
Loading...
Need help?
General
