EasyManuals Logo

Epson LX-300+ User Manual

Epson LX-300+
138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
2-4 Using the Printer
R4C4610
Rev. C
A5 size USING.FM
6/28/00 Pass 3
L
Proof Sign-off:
SEI Y.Ohkawara K.Kono
K.Kono
SEI M.Kauppi
Selecting fonts
After entering the micro adjust mode by holding down the
Pause
button for three seconds, you can change font settings with the
Tear Off
button. The two font lights come on (
n) and go off (
o)
to show the current selection. Press the button repeatedly to cycle
through all of the available selections; then stop when you reach
the desired font.
Your selection stays in effect until you change it again or turn off
the printer. However, any font choices you make with your
software will cancel your control panel selection. The table below
shows how the
Tear Off
lights appear for each selection.
n
= on
o
= off
f
= flashing
Font FONT
Light
1 2
Sample
EPSON Draft
o n
EPSON Draft condensed
o f
EPSON Roman
n o
EPSON Roman condensed
n n
EPSON Sans Serif
n f
EPSON Sans Serif condensed
f o

Table of Contents

Other manuals for Epson LX-300+

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson LX-300+ and is the answer not in the manual?

Epson LX-300+ Specifications

General IconGeneral
EmulationEpson ESC/P, IBM PPDS
Print Method9-pin, impact dot matrix
InterfaceParallel
Paper HandlingFriction feed
Dimensions366 x 275 x 159 mm
Paper Width4 - 10 inches

Related product manuals