2
Using the Printer 2-3
R4C4610
Rev. C
A5 size USING.FM
6/28/00 Pass 3
R
Proof Sign-off:
SEI Y.Ohkawara K.Kono
K.Kono
SEI M.Kauppi
Tear Off
lights
The two green
Font
lights indicate the current font setting. For
more about selecting fonts, see “Selecting fonts” on page 2-4.
Both
Font
lights will flash when continuous paper is in the
tear-off position. For more about the tear-off position, see
“Adjusting the tear-off position” on page 2-18.
Load/Eject
button
When using sheet fed paper, pressing the
Load/Eject
button
will eject a sheet of paper. When using continuous paper with
the push tractor, pushing the
Load/Eject
button will load the
paper from the standby position, or return loaded paper to
the standby position.
LF/FF
button
You can press the
LF/FF
button briefly to feed paper line by
line. Holding it down will eject single sheets, or advance
continuous paper to the next top-of-form position.
Tear Off
button
When using continuous paper with the push tractor, pushing
the
Tear Off
button will advance the paper to the tear-off
position. After tearing off the printed document, pushing this
button again will return the continuous paper to the top-of-
form position.
Font
After entering the micro adjust mode by holding down the
Pause
button for three seconds, you can change font settings
with the
Tear Off
button.
Micro Adjust
When you hold down the
Pause
button for three seconds, the
printer enters the micro adjust mode. In this mode, you can
press the
LF/FF
and
Load/Eject
buttons to adjust the top-of-
form or tear-off position.
To Next Page
Loading...
Need help?
General
