2
Using the Printer 2-15
R4C4610
Rev. C
A5 size USING.FM
6/28/00 Pass 3
R
Proof Sign-off:
SEI Y.Ohkawara K.Kono
K.Kono
SEI M.Kauppi
If you want to change the position where printing begins on the
page, press
LF/FF
to advance the page to the next top-of-form
position, and then see “Adjusting the Top-of-Form Position”
below to adjust the loading position.
To eject the paper, tear off the paper entering the printer; then
press the
LF/FF
button to feed the paper forward.
Adjusting the top-of-form position
The top-of-form position is the position on the page where the
printer starts printing. If your printing appears too high or low
on the page, you can use the micro adjust feature to adjust the top-
of-form position. Follow these steps:
c
Caution:
Never use the knob to adjust the top-of-form position; this may
damage the printer or cause it to lose the top-of-form position.
Note:
❏
Your top-of-form position setting remains in effect until you change
it, even if you turn off the printer.
❏
The top margin setting made in some application software overrides
the top-of-form position setting you make with the micro adjust
feature. If necessary, adjust the top-of-form position in your
software.
1. Make sure the printer is turned on.
2. If necessary, load paper as described earlier in this chapter.
3. Lift the printer cover up and off the printer.
4. Hold down the
Pause
button for about three seconds. The
Tear Off
light starts flashing and the printer enters the micro
adjust mode.
To Next Page
Loading...
Need help?
General
