2
Using the Printer 2-35
R4C4610
Rev. C
A5 size USING.FM
6/28/00 Pass 3
R
Proof Sign-off:
SEI Y.Ohkawara K.Kono
K.Kono
SEI M.Kauppi
13. Slide the left edge guide to the center until it stops at the guide
mark. Then slide the right edge guide to the opposite guide
mark.
Note:
To remove the paper guide from the cut-sheet feeder, press both
release tabs and pull out the paper guide.
You can easily switch between continuous paper and cut-sheet
feeder operation. See “Switching back to single sheets” on page
2-10 for details.
Note:
When you print several pages of continuous paper, fold the first printed
page forward at the perforation after the perforation emerges from below
the printer cover. This helps the printer feed the printed pages properly
and prevents paper jams.
Pull tractor unit
An additional pull tractor (C80030✽) is available as an option.
You can improve the performance of continuous paper handling
by using two tractors at the same time. This is especially useful
with continuous pre-printed forms, multipart forms, and labels.
When you use two tractors, set
Tractor
in the Printer Setting mode
to
Double
.
1. Make sure the paper-release lever is pulled forward to the
continuous-paper position. Install the included tractor in the
push-tractor position. Install the optional tractor in the pull-
tractor position.
2. Load continuous paper on the sprocket units of the push-
tractor. (See “Printing on Continuous Paper” on page 2-5.)
3. Turn on the printer. Hold down the
LF/FF
button to feed paper
in one page.
To Next Page
Loading...
Need help?
General
