4
Troubleshooting 4-9
R4C4610
Rev. C
A5 size TRBLE.FM
6/28/00 Pass 3
R
Proof Sign-off:
SEI Y.Ohkawara K.Kono
K.Kono
SEI M.Kauppi
Switching between the cut-sheet feeder and the push
tractor does not work properly
Make sure the edge guide positions are correct. Position the edge
guides at the diamond-shaped guide marks.
There may be only one sheet left in the bin. Add more paper.
Two or more sheets feed at one time.
You may have loaded too many sheets in the cut-sheet feeder’s bin.
You may have forgotten to fan the stack of paper before loading it into
the bin. Remove the paper and fan it.
The paper feed is crooked.
The paper may be old or creased. Use only new, clean sheets of paper.
There may be too much paper in the stacker.
Make sure that the paper guides are set correctly and that your paper
is the proper size and quality. See “Printer Specifications” on page A-4
for paper specifications.
One page of printing has spread to two pages.
Your software application settings may be incorrect. Check that the
page-length setting and lines-per-page setting in your software are
correct.
The desired paper type does not load.
The paper-release lever may not be in the proper position. Pull the lever
forward to load continuous paper or push the lever back to load single
sheets.
To Next Page
Loading...
Need help?
General
