1-10 Setting Up the Printer
R4C4610
Rev. C
A5 size SETUP.FM
6/28/00 Pass 3
L
Proof Sign-off:
SEI Y.Ohkawara K.Kono
K.Kono
SEI M.Kauppi
Plugging in the printer
1. Make sure the power switch on the printer is turned off. It is
off when the
N side of the switch is pressed down.
2. Check the label on the back of the printer to make sure the
voltage required by the printer matches that of your electrical
outlet.
c
Caution:
If the rated voltage and your outlet voltage do not match,
contact your dealer for assistance. Do not plug in the power
cord.
3. If the power cord is not attached to the printer, connect it to
the AC inlet on the printer.
4. Plug the power cord into a properly grounded electrical
outlet.
To Next Page
Loading...
Need help?
General
