Maintenance 9. Cable Unit
164 S5 Rev.5
CAUTION
■
disconnecting the connectors during the replacement of the cable unit, be
sure to reconnect the connectors to their proper positions.
Improper connection of the connectors may result in improper function of the
robot system.
For details on the connections, refer to
the Maintenance 9.2 Connector Pin
alcohol
, liquid gasket, and adhesive following respective
instructions
and also instructions below. Careless use of alcohol, liquid gasket,
or adhesive may cause a fire and/or safety problems.
- Never put alcohol, liquid gasket, or adhesive close to fire.
- Use alcohol, liquid gasket, or adhesive while ventilating the room.
- Wear protective gear including a mask, protective goggles, and oil-resistant
gloves.
- If alcohol, liquid gasket, or adhesive gets on your
thoroughly with soap and water.
- If alcohol, liquid gasket, or adhesive gets into your eyes or mouth, flush your
eyes or wash out your mouth with clean water thoroughly, and then see a
doctor immediately.
including a mask, protective goggles, and oil-resistant
gloves during grease up. If grease gets into your eyes, mouth, or on your skin,
follow the instructions below.
If grease gets into your eyes : Flush them thoroughly with clean water, and
then see a doctor immediately.
If grease gets into your mouth : If swallowed, do not induce vomiting. See a
doctor immediately.
If grease just gets into your mouth, wash out
your mouth with water thoroughly.
If grease gets on your skin : Wash the area thoroughly with soap and
water.
To Next Page
Loading...
Need help?
General
