Epson ProSix S5 Series - Page 26

Setup & Operation 1. Safety
12 S5 Rev.5
Mount the brake release unit
(1)
Turn OFF the controller.
(2)
Remove the external short connector.
External short connector
(3)
Connect the brake release unit to the
connector of the connection cable.
Connector of the
connection cable
Remove the brake release unit
(1)
T
urn OFF the brake release unit.
(2)
Remove the power cable of the brake release unit.
(3)
Disconnect the brake release unit from the
connector of connection cable.
(4)
Connect the external short connector to the
connector of connection cable.