SC-S30600 Series Revision B
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 167
Confidential
3.4.6.8 Suction Fan
1. Remove the After Heater. (p174)
2. Remove the Cooling Fan. (p175)
3. Release the cables from the 11 clamps.
4. Disconnect the cable from the three relay connectors.
5. Disconnect the cables from the connectors (CN500, CN501, CN502, CN504, and
CN512) on the Sub-E Board.
Figure 3-126. Releasing the Cables
A D J U S T M E N T
R E Q U I R E D
When replacing/removing this part, refer to “4.1.2 Adjustment
Items and the Order by Repaired Part” (p200) and make sure to
perform the specified operations including required adjustment.
Relay Connector
Clamp
Sub-E Board
Relay Connectors
Sub-E Board
CN512
CN504
CN500
CN502 CN501
To Next Page
Loading...
