Loading transparencies
When printing on transparencies, use only EPSON
Transparency film S041030 (Letter). For best results, use
transparencies within six months of opening the package.
1. Make sure the printable surface of the transparencies is
face down. The printable side is face down when the cut
corner is on the bottom right as you hold the transparencies
in front of you.
c
Caution:
Do not touch the printable surface; hold the sheets by their
edges.
2. Insert up to 50 transparencies into the sheet feeder until
they meet resistance.
3. Adjust the left and rear edge guides so that the
transparencies feed straight into the paper path.
4. Select Transparency and 360 dpi resolution in the printer
driver setup as shown in Chapter 3.
Choosing and Loading Paper
2-5
To Next Page
Loading...
Need help?
General
