Using Special Power-On Functions
These functions are available when you hold down the
following buttons when turning on the printer:
Self test (Operate + Load/Eject)
Checks the paper length and performs self-test printing. See
Chapter 1, “Testing the Printer.”
Hex dump (Operate + Font + Load/Eject)
Prints the print data in hexadecimal code. See page 6-5.
Demonstration ( Operate + Alt)
Prints a demonstration page.
Default setting (Operate + Economy/Condensed)
Enters the default-setting mode. See “Using the Default-Setting
Mode” on page 4-10 for details.
Note:
To exit the hex dump, demonstration, or default-setting modes, press
the
Pause
button and then the
Operate
button to turn off the
printer.
4-6
The Control Panel
To Next Page
Loading...
