Transporting the Printer
If you need to transport your printer some distance, carefully
repack it using the original box and packing materials as
follows:
1. Open the printer cover and make sure that the print head is
capped in the far right position. If the print head is not
capped, turn on the printer to cap it. Then turn off the
printer.
c
Caution:
Transporting the printer without the cartridges installed
can damage the printer.
2. Unplug the power cord from the electrical outlet; then
disconnect the interface cable from the printer.
3. Remove the paper from the sheet feeder.
4. Attach the protective material to the printer. See the Notice
Sheet that came in the box.
5. Repack the printer in the original box.
6. Keep the printer flat in the box during transport.
If the printed image is faint, has gaps, or nothing prints when
you first use the printer after transport, clean the print heads.
See “Cleaning the Print Heads” earlier in this chapter. If the
printed image is misaligned, calibrate the printer as described
in Chapter 1, “Setting Up.”
5-8
Maintenance
To Next Page
Loading...
Need help?
General
