-138
1. Double-click the My Computer icon and double-click the
Control Panel.
2. Double-click the System icon and click the Device Manager
tab.
3. Double-click the Ports (COM & LPT) icon and double-click
LPT1. If you have connected your printer to a port other than
LPT1, double-click the appropriate port icon.
4. Click the Resources tab and select the Use automatic
settings check box to deselect the Automatic Setting. Write
down the Input/Output Range settings shown in the
Resource settings box.
5. Select a basic configuration setting from the Setting based
on list that uses the same Input/Output Range settings as
those you wrote down in step 4, and make sure the Direct
Memory Access channel and Interrupt Request numbers are
allocated and displayed. Confirm also that the Conflicting
device list box shows No conflicts.
Write down
these settings
Click here to clear
the check box
To Next Page
Loading...
