Epson Stylus Pro 10600 - To Use Your Printer with a Macintosh

-30
To use your printer with a Macintosh
To use this printer, your Apple
®
Macintosh
®
must meet the
following system requirements. You also need a USB cable to
connect this printer to your Macintosh.
*1 is for graphic data use
*2 is for line data use
Note:
❏ The amount of available memory varies according to the number and
kind of applications that are open. To see how much memory is
available, choose About This Macintosh from the Apple menu
and refer to the memory size (listed in kilobytes) under “Largest
Unused Block” (1,024 K = 1 MB).
❏ The memory requirements above are for printing on B0 (1030 × 1456
mm) size paper. These requirements may vary depending on the size
of the paper, the type of application you are using, and the
complexity of the document you want to print.
❏ The available interface varies according to Macintosh system
version as follows:
Network interface: 8.5.1 to 9.x
USB interface: 8.5.1 to 9.x
Type-B interface: 8.6.x to 9.x
Minimum system Recommended system
PowerPC PowerPC G3 350MHz*
1
/PowerPC
G3 300 MHz*
2
or higher processor
Mac OS 8.5.1 Mac OS 9.1 or later
11 MB of available memory
14 MB of available memory when
background printing is turned on.
33 MB or more of available memory
56 MB of available memory when
background printing is turned on.
- 500 MB*
1
/300 MB*
2
or more free disk
space (B0)