-119
Adjusting page settings
You can adjust the following settings on the “Paper Menu”.
Drying Time
per Print Head
Pass
Adjusts the Drying Time per Print Head Pass. Use a value
in the range of 0 to +50 (5.0sec), in 0.1sec increments.
Drag the scroll bar to the right or left with your mouse to
adjust the setting. You can also type a number (0 to +50)
in the box next to the slide bar.
Paper Feed
Adjustment
Adjusts the amount of Paper Feed Adjustment. Use a
value in the range of -70 to +70. The units are 0.01%. Drag
the scroll bar to the right or left with your mouse to adjust
the setting. You can also type a value (-70 to +70) in the
box next to the slide bar.
If you adjust the setting, try at least a 6 unit difference from
the prior value, to create a visual difference on the
sample print.
Paper
Thickness
Enter the Paper Thickness value in the range of 0 to +15.
You can specify a value in the range of 0 to 1.5mm, in
0.1mm increments.
Paper Suction Adjusts the Paper Suction value. You can select from
Standard (100%), -1(50%), -2(30%), -3(10%) or -4(6%).
For thin media, reducing the value will help paper
feeding.
Cut Method From the pop-up menu, select a Cut Method for thin
paper. You can select from Standard, Thin Paper or Very
Thin Paper.
Orientation Use this setting to specify the direction of printing on
the page: Portrait (vertical), or Landscape
(horizontal). If you need to print close to the bottom
of the page, click Rotate by 180°.
Printable area Select Centered to position your printout at equal
distances from the edges of the paper. This setting is
available only for sheets.
Mode Description
To Next Page
Loading...
