-248
Note:
Do not touch the
Manual
switch while printing is in progress.
Doing so may damage your prints.
Removing paper after take-up
After paper take-up, remove the take-up reel core as follows.
1. Turn off the Auto Take-up Reel Unit.
w
Warning:
Turn off the Auto Take-up Reel Unit before removing the
take-up reel core. If the take-up reel unit operates
unexpectedly, injury may occur.
2. Press the Paper Source button repeatedly on the printer until
the Roll Auto Cut light comes on.
Then press the Cut/Eject button. The roll paper is cut
automatically.
Note:
If you are printing on very thick roll paper, it is recommended that
you set the Auto Cut setting to off (at the printer’s control panel
and printer driver) and press the
Paper Feed
button on the printer
to feed the paper, then cut the paper yourself; otherwise the paper
cutter may be damaged. See “Cutting the roll paper manually”.
To Next Page
Loading...
