-89
Head alignment pattern examples:
6. After printing, the pattern number and current set number
are displayed. Select the set that has the smallest gaps, then
press the + or - button to display the number for that set.
7. Press the Enter button to register the set number. The next
pattern number appears. Then repeat step 6.
8. After you set the pattern(s), press the Pause button to return
to the READY status.
Note:
You can return to step 6 by pressing the Enter button.
Setting the paper thickness
When you use media other than EPSON special media, you may
need to set the paper thickness. You can select whether the
thickness of the paper you are using is determined automatically
(STD (standard)) or by the registered value (1 to 10) in the Paper
Settings menu. To register and recall the settings you made, see
the following sections. You can also register the ink drying time
for respective paper settings including STD. To select the
registered setting, see “Selecting the registered settings”.
To Next Page
Loading...
