Epson Stylus Pro 10600 - Attaching and Removing the Spindle from the Printer

-193
3. Remove the roll paper from the spindle.
4. Attach other roll paper to the spindle (see “Attaching the roll
paper to the spindle”), or if you do not want to attach other
roll paper, slide the movable flange back onto the spindle.
Note:
Store unused roll paper in its original package. Put the roll paper into
the plastic bag, and outer package so as to avoid moisture problems.
Attaching and removing the spindle from the
printer
To attach the paper loaded spindle to the printer, follow the steps
below. When you remove the spindle from the printer, clear the
roll paper from the paper insertion slot, then reverse the steps
below.
You can mount two roll paper spindles on your printer at once in
the following combinations:
❏ two 2-inch roll paper spindles
❏ one 2-inch roll paper spindle and one 3-inch roll paper spindle
Note:
❏ If you mount one 2-inch roll paper spindle and one 3-inch roll paper
spindle at once, always mount the 3-inch type on the upper side
brackets and the 2-inch type on the lower brackets.