Epson Stylus Pro 10600 - Adjusting Page Settings

-173
Note:
Paper Configuration settings are available only when using
UltraChrome ink.
Adjusting page settings
You can adjust the followings in the “Page Setup dialog box”.
Mode Description
Color Density Adjusts the strength of Color Density. Use a value in the
range of -50% to +50%. Drag the scroll bar to the right or
left with your mouse to adjust the setting. You can also
type a number (-50 to +50) in the box next to the slide bar.
Drying Time
per Print Head
Pass
Adjusts the Drying Time per Print Head Pass. Use a value
in the range of 0 to +50 (5.0sec), in 0.1sec increments.
Drag the scroll bar to the right or left with your mouse to
adjust the setting. You can also type a number (0 to +50)
in the box next to the slide bar.
Paper Feed
Adjustment
Adjusts the amount of Paper Feed Adjustment. Use a
value in the range of -70 to +70. The units are 0.01%. Drag
the scroll bar to the right or left with your mouse to adjust
the setting. You can also type a value (-70 to +70) in the
box next to the slide bar.
If you adjust the setting, try at least a 6 unit difference
from the prior value, to create a visual difference on the
sample print.
Paper
Thickness
Enter the Paper Thickness value in the range of 0 to +15.
You can specify a value in the range of 0 to 1.5mm, in
0.1mm increments.
Paper Suction Adjusts the Paper Suction value. You can select from
Standard (100%), -1(50%), -2(30%), -3(10%) or -4(6%).
For thin media, reducing the value will help paper
feeding.
Cut Method From the pop-up menu, select a Cut Method for thin
paper. You can select from Standard, Thin Paper or Very
Thin Paper.