Epson Stylus Pro 10600 - Printing a Status Sheet

-92
Note:
When you are loading very thin paper, set the Suction setting to
WEAKEST.
16. Press the Enter button to save the selected value.
17. Press the Pause button to exit the SelecType mode.
Selecting the registered settings
To select the registered settings, follow the steps below.
1. In the SelecType mode, press the SelecType button until
PAPER CONFIG MENU appears on the LCD panel.
2. Press the Item button. You may see PAPER NUMBER.
3. Press the + or - button to select the number registered that you
want to use. If you select STD, the printer prints data according
to the driver settings. If you select No. X, the control panel
settings override the driver settings unless you select AUTO in
PAPER THK NO.. Then press the Enter button.
4. Press the Pause button to exit the SelecType mode.
Printing a status sheet
In SelecType mode, a status sheet can be printed to see the current
SelecType default values.
1. Load paper as described in “Using Roll Paper” or “Using Cut
Sheet Media”.
2. In SelecType mode, press the SelecType button until TEST
PRINT MENU is displayed.
3. Press the Item button until STATUS CHECK is displayed.