Epson Stylus Pro 10600 - Performing the Head Alignment

-88
Performing the head alignment
How to perform the head alignment by SelecType is described
below.
1. Load paper in your printer as described in “Using Roll Paper”
or “Using Cut Sheet Media”.
Note:
For best results, use the media you want to print your image on
when printing the head alignment pattern.
2. In SelecType mode, press the SelecType button until HEAD
ALIGNMENT MENU is displayed on the LCD panel.
3. Press the Item button. PAPER THICK appears. When you want
to print on EPSON media, leave this setting as STD. When you
want to print on non-EPSON media, enter the thickness value
of the paper in 0.1 mm increments by pressing the + or -
button.
4. Press the Enter button to register your value. ALIGNMENT=Bi-D
LC appears.
5. Press the Enter button. The printer starts printing head
alignment pattern.
Note:
This pattern is printed in only Light Cyan. If you want to align the
print heads in all colors, or if you find some problems with the result
in Light Cyan, select Bi-D ALL. If you still have some problems with
the result in all colors, align the print heads with Uni-D.