Epson Stylus Pro 10600 - Removing the Roll Paper from the Spindle

-192
2. Place the roll paper on a flat surface so that it does not unwind.
Slide the roll paper onto the spindle and onto the flange until
it fixes into place.
3. Slide the movable flange (removed in step 1) onto the spindle
and into the end of the roll paper until it fixes into place.
Removing the roll paper from the spindle
To remove the roll paper from the spindle, follow the steps below.
1. Place the paper loaded spindle down on a flat surface.
2. Slide the movable flange off the end of the spindle by tapping
the same end of the spindle with your hand to loosen it. The
flange is removed.
c
Caution:
To remove the movable flange from the spindle, do not hold
the spindle vertically and tap the end on the floor; otherwise,
damage may occur.