Epson Stylus Pro 10600 - Blurry or Smeared Printout

-264
❏ Run the Head Cleaning utility to clear any clogged ink
nozzles. See “Using the Printer Utilities” for Windows or
“Using the Printer Utilities” for Macintosh.
❏ Check the Ink Out lights. If necessary, replace ink cartridges.
See “Replacing Ink Cartridges”.
❏ Select thinner paper in the SelecType mode. Check the paper
number setting in the Paper Configuration menu. See
“SelecType Settings”.
❏ The platen gap may be too wide for your paper. Change the
platen gap setting from WIDE to STANDARD in the Printer Setting
menu of the SelecType mode. See “SelecType Settings”.
Blurry or smeared printout
Try one or more of these solutions:
❏ For Windows, check the Media Type setting in the Main
menu. Make sure it is correct for the paper you are using.
For Macintosh, check the Media Type setting in the Print
dialog box. Make sure it is correct for the paper you are using.
❏ If the paper you are using is not supported by the printer
driver, set the paper thickness using the SelecType setting. See
“SelecType Settings”.
❏ Make sure your paper is dry and the printable side is face-up.
Also, make sure you are using the correct type of paper. See
“Paper” for specifications.
❏ Ink may have leaked inside the printer; wipe the inside of the
printer with a soft, clean cloth.