Epson Stylus Pro 10600 - Print Adjustment; Drying Time

-78
PAPER NUMBER
When STD is selected, the printer determines paper thickness
automatically. You can also select No. X (X can be any number
between 1 to 10) to register the following settings or to recall the
following settings you made.
❏ Thickness number
❏ Cut pressure
❏ Cut method
❏ Paper feed adjustment
❏ Print adjustment
❏ Drying time
❏ Suction
Note:
If you select STD, the printer prints data according to the driver
settings. If you select No. X, the control panel settings override the
driver settings unless you select AUTO in PAPER THK NO..
THICK PAT.
Prints the paper thickness detection pattern. If STANDARD is
selected in PAPER NUMBER, the pattern is not printed.
PAPER THK NO.
If you use EPSON special media, you should normally select AUTO.
If you use non-EPSON special media, confirm the paper thickness
detection pattern, and enter the number for the print pattern with
the smallest gap.