Epson Stylus Pro 10600 - Loading the Roll Paper

-196
6. Close the roll paper cover.
Loading the roll paper
To load roll paper, follow the steps below.
Note:
You may want to setup the paper basket before printing. See “Setting
the Paper Basket”. (In the illustrations below the paper basket is set to
feed paper backwards.)
1. Open the roll paper cover. Make sure that the roll paper is
attached to the printer properly.
Note:
If two roll paper spindles are attached to the printer, keep the unused
roll wound up using the roll paper belt to avoid paper jams. See
“Using the roll paper belt”.
2. Make sure that the printer is on.
3. Press the Paper Source button repeatedly until the Roll Auto
Cut light or Roll Cutter Off light is on.