-247
c
Caution:
During operation, be sure to stay out of the sensor detection area.
Interrupting the sensor beam can cause paper to be taken up under
tension and adversely affect printing.
1. Press the Paper Source button on the printer repeatedly until
the Roll Cutter Off light comes on.
2. Set the direction of take-up with the Auto switch on the
control box.
3. Send a print job to the printer. The printer starts printing. The
Auto Take-up Reel Unit takes-up the roll paper in the
direction you set in step 2.
To wind forward To wind backward
Light
detector
Light
emitter
Light detector sensor
detection area
To Next Page
Loading...
