EPSON Stylus Pro 7500 Revision A
Disassembly & Assembly Disassembly Flow 114
Figure 4-31. C299MAIN DIP Switch Settings
NOTE: Jumpers J1 and J2 should be used with the short setting as is. If the
setting is changed, the printer will cease to operate.
4.2.3 Printer Mechanism Disassembly
This section describes the Printer Mechanism components and the procedure for
disassembly.
ON
SW2 SW1
CAUTION
Do not remove or loosen the screws that secure the CR guide rail, also
do not remove the carriage. These parts are adjusted to 1/100th of a
mm at the factory.
Do not attempt any kind of service or adjustment to the frame or parts
attached directly to the frame. See the Parts List in Chapter 7 for a list
of parts that you can service/replace. Other parts can only be
assembled and adjusted at the factory.
To Next Page
Loading...
