EPSON Stylus Pro 7500 Revision A
Adjustment Adjustment Steps 219
5.2.6 Mechanism Adjustment
This section describes the mechanism adjustments you need to perform when replacing or
removing certain parts. The parts and their corresponding adjustments are as follows.
Table 5-19. Necessary Mechanism Adjustments
Parts Adjustment Necessary Tools Refer to
CR Motor CR Steel Belt Tension
Tension Gauge #F712
code: 1047744
Standard: 8,000g
page 220
PF Motor PF Belt Tension
Tension Gauge
code: B747700300
Standard: 4,000g
page 221
P THICK sensor
Self-diagnostic test -
"Paper Thickness"
6/7mm schema gauge(s)
page 222
Cover Open
sensor
Self diagnostic test -
"Cover"
----
page 223
CR Encoder
Sensor
CR encoder installation
position adjustment.
Exclusive tool #F757
Code: 1059436
page 224
CR Encoder
Scale
CR encoder scale
installation position
adjustment
Exclusive tool #F758
Code: 1059440
page 225
Cutter Solenoid
Cutter positioning
adjustment
Exclusive tool #F763
Code: 1060656
page 226
PF Encoder
Sensor
PF ENC installation
position adjustment
PF ENC installation
position adjustment 2
Exclusive tool #F764
Code: 1060658
Exclusive tool #F765
Code: 1060657
page 230
To Next Page
Loading...
