Epson Stylus Pro 7500 - Adjustment Outline; Cautions

EPSON Stylus Pro 7500 Revision A
Adjustment Adjustment Outline 170
5.1 Adjustment Outline
This section describes the adjustment procedures necessary after replacing certain parts and
explains how to perform those adjustment procedures.
5.1.1 Cautions
Before beginning the adjustment operation, be sure to confirm the following caution items.
5.1.2 Adjustment Tools
The necessary tools for performing adjustment procedures on this printer are shown below.
The mechanical adjustment tools are not mentioned in the following table and “Mechanism
Adjustment” on page 219.
CAUTION
n If you are carrying out adjustments, see Table 5-2 and then
confirm the relevant adjustment items and adjustment
procedures.
n When carrying out adjustments, check the cautions displayed in
the explanation for each adjustment item thoroughly. If the
operation is performed wrong, it could hinder the product’s
operation or functions.
n When carrying out adjustments accompanying replacement of
the following parts, be sure to install and use new ink cartridges.
Ink supply system parts replacement (Heads, I/H Assembly, Ink
tubes, Head damper)
Table 5-1. Adjustment Tools
Name Part Code Notes
Tension Gauge
1054053/standard
tool acceptable
Max. 10,000g
Tension Gauge
B747700300/
standard tool
acceptable
Max. 4,000g
Flash Memory Card
#F727 (x 2)
1050073 /
Commercially
available product can
be used.
Specifications: 2 MB Flash memory card
Type-II PCMCIA Rel. 2.1 / JEIDA
Ver. 4.2)
5 V single operation specifications
24-inch Wide Roll
Paper (MCSP24R4)
Epson or
commercially
available paper
(Thick mat paper roll)
For printer mechanism adjustments and test
printing.
A3 Tracing Paper
Microtrace #300
LMB, made by
Kimoto #F751
(1057723)
Used for adjustment of the paper status
detection sensor (P_FRONT, P_REAR) level
adjustment.
A3 Copy Paper (PPC)
Commercially
available product
(Example: Fuji Xerox
Bright Recycled)
Used for adjustment of the paper status
detection sensor (P_EDGE) level adjustment.